What absorbs at 2335 cm⁻¹ in an FTIR spectrum?
A band near 2335 cm⁻¹ can point to several functional groups. Below are the most likely assignments, ranked by how much published evidence supports each — every one traceable to literature (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 4 cited sources
Quick answer
A band near 2335 cm⁻¹ is usually interpreted by checking which functional groups repeatedly co-occur there in the literature, then confirming at least one or two additional peaks in the same sample. This page ranks those assignments by accumulated evidence rather than by a single fixed textbook rule.
Возможные назначения функциональных групп
| Функциональная группа | Подтверждающие факты | Цитируемые источники | Максимальная достоверность |
|---|---|---|---|
| Thiol | 1 | 1 | 1,0 |
| Carbon dioxide | 1 | 1 | 1,0 |
| Urethane | 1 | 1 | 1,0 |
| Methacrylate | 1 | 1 | 1,0 |
| Ketone | 1 | 1 | 1,0 |
| Ester | 1 | 1 | 1,0 |
| Carboxyl (COOH) | 1 | 1 | 1,0 |
| Carbonyl (C=O) | 1 | 1 | 1,0 |
| Amide | 1 | 1 | 1,0 |
| Acetate | 1 | 1 | 1,0 |
Ранжирование отражает накопленные литературные данные, а не единственное авторитетное правило. Всегда проверяйте в контексте вашего образца.
Possible materials
| Материал | Поддерживающие пики | Overlapping groups | Цитируемые источники |
|---|---|---|---|
| polyurethanes | 2335, 1740, 1728 | Methacrylate, Urethane | 1 |
| edible oils | 2335, 1743, 1064 | Methacrylate | 1 |
| GO | 2335, 1720, 1182 | Methacrylate | 1 |
| RGO | 2335, 2358, 2930 | Methacrylate | 1 |
Materials are shown only when the same literature pool supports this band and at least one additional characteristic peak.
Spectrum logic
This band becomes meaningful only when read with its neighboring peaks. In practice, analysts first look at the assignments above, then check whether the same sample also shows other peaks expected for the same structural motif. A lone band near 2335 cm⁻¹ is usually not enough for material identification by itself.
Real-world usage
This type of query is common in polymer identification, unknown plastic screening, QC troubleshooting, recycled-material verification, and literature-backed peak assignment review.
Common mistakes
- Treating one isolated band as proof of a material without checking at least one or two supporting peaks.
- Ignoring overlap: multiple functional groups can contribute near the same wavenumber.
- Skipping validation when additives, blends, oxidation, or contamination may distort the spectrum.
Verification advice
When ambiguity remains, validate the hypothesis with DSC, GC-MS, or TGA, especially for blends, degraded samples, and filled polymers.
Литература, лежащая в основе этих назначений
-
Acetate достоверность 1,0
“However, the three cm-1 peaks appearing in the range between 2270 and 2410 are attributed to urethane groups, while the absorption peak cm-1 at 2335 might be due to C=O stretching (bonded) in cm-1are urethane.”
Analysis of silver nanoparticles produced by chemical reduction of silver salt solution DOI: 10.5755/j01.ms.22.4.12503 -
Carbon dioxide достоверность 1,0
“Characteristic cm(cid:1)1 in the carbon dioxide bands at 2335 and 2366 assigned to bands for small (dimeric) and larger water clusters, and bulk- (cid:5)3600, dioxide51 shows that it asymmetric stretching modes of carbon like water are dist”
Ngoc Minh Nguyen Huynh 等 - 2018 - Reduced graphene oxide as a water, carbon dioxide DOI: 10.1039/c8ra03080d -
Thiol достоверность 1,0
“cm(cid:2)1 S-H The characteristic bands of at 2335 and 2362 were still γ A method of grafting a mesoporous -alumina layer, supported present with no change in intensity.”
PDMS grafting of mesoporous γ-alumina membranes for nanofiltration of organic solvents DOI: 10.1016/j.memsci.2014.07.010 -
достоверность 0,9
“CO absorption band”
Stoichiometric Determination of Moisture in Edible Oils by Mid-FTIR Spectroscopy DOI: 10.1016/j.aca.2016.03.016
Есть спектр с этой полосой?
Загрузите свой FTIR-спектр и получите полный отчет об интерпретации — назначение пиков с цитированием литературы, совпадения с библиотекой и цепочку доказательств с оценкой достоверности — за секунды.