What absorbs at 1223 cm⁻¹ in an FTIR spectrum?
A band near 1223 cm⁻¹ can point to several functional groups. Below are the most likely assignments, ranked by how much published evidence supports each — every one traceable to literature (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 8 cited sources
Réponse rapide
A band near 1223 cm⁻¹ is usually interpreted by checking which functional groups repeatedly co-occur there in the literature, then confirming at least one or two additional peaks in the same sample. This page ranks those assignments by accumulated evidence rather than by a single fixed textbook rule.
Attributions possibles de groupes fonctionnels
| Groupe fonctionnel | Faits à l＇appui | Sources citées | Confiance maximale |
|---|---|---|---|
| Methoxy (OCH3) | 6 | 6 | 1,0 |
| Methacrylate | 6 | 6 | 1,0 |
| C-O single bond | 6 | 6 | 1,0 |
| Acetate | 6 | 6 | 1,0 |
| Amide | 3 | 3 | 1,0 |
| Hydroxyl (O-H) | 2 | 2 | 1,0 |
| Secondary amine | 2 | 2 | 1,0 |
| C n single bond | 2 | 2 | 1,0 |
| Ketone | 1 | 1 | 1,0 |
| Ester | 1 | 1 | 1,0 |
| Carboxyl (COOH) | 1 | 1 | 1,0 |
| Carbonyl (C=O) | 1 | 1 | 1,0 |
| C c single bond | 1 | 1 | 1,0 |
| N-O bond | 1 | 1 | 1,0 |
| Alkyl C-H | 1 | 1 | 1,0 |
| Aromatic ring | 1 | 1 | 1,0 |
Le classement reflète les preuves bibliographiques accumulées, et non une règle faisant autorité. Confirmez toujours dans le contexte de votre échantillon.
Logique du spectre
This band becomes meaningful only when read with its neighboring peaks. In practice, analysts first look at the assignments above, then check whether the same sample also shows other peaks expected for the same structural motif. A lone band near 1223 cm⁻¹ is usually not enough for material identification by itself.
Utilisation réelle
Ce type de requête est courant dans l＇identification des polymères, le criblage des plastiques inconnus, le dépannage du contrôle qualité, la vérification des matériaux recyclés et l＇examen de l＇attribution des pics appuyée par la littérature.
Erreurs courantes
- Traiter une bande isolée comme preuve d＇un matériau sans vérifier au moins un ou deux pics de support.
- Ignorer le chevauchement : plusieurs groupes fonctionnels peuvent contribuer près du même nombre d＇onde.
- Sauter la validation lorsque des additifs, des mélanges, l＇oxydation ou la contamination peuvent déformer le spectre.
Conseil de vérification
Lorsque l＇ambiguïté persiste, validez l＇hypothèse avec DSC, GC-MS ou TGA, en particulier pour les mélanges, les échantillons dégradés et les polymères chargés.
Bibliographie derrière ces attributions
-
Aromatic ring confiance 1,0
“cm-1, 2950 to 2840 the aromatic ring CH band at cm-1, cm-1 1223 and a peak near 490 (Fig.”
Calderon 等 - 2011 - Chemical Differences in Soil Organic Matter Fracti DOI: 10.2136/sssaj2009.0375 -
Acetate confiance 1,0
“The 1223 band was assigned to C-O vibrations.”
Can 等 - 2023 - Choline Chloride-Based Deep Eutectic Solvent-Treat DOI: 10.3390/f14030569 -
N-O bond confiance 1,0
“3 here) The IR spectrum of original sPS film showed that there is no absorption at 1223 cm-1 which is one of the characteristic trans planar conformation bands of mesophase.”
Investigation on the overlapping bands of sydiotactic polystyrene by using 2D-IR spectroscopy DOI: 10.1016/j.molstruc.2016.03.103 -
Acetate confiance 1,0
“Addition it is observed by an increase of intensity of and 1223cm-1, C-O of 6% pMDI resulted in less weight less than the addition of respectively, by absorptions at 1700 and 2% pMDI and 4% pMDI, in the temperature range between increasing”
El-Shekeil 等 - 2012 - Effect of pMDI isocyanate additive on mechanical a DOI: 10.1177/0021998310385030) -
Acetate confiance 1,0
“C=O bending in carboxylic esters and the band at 1223 In particular, silver does exist in nature especially in leadascribable to C-O stretching in carboxylic esters (Bonizzoni based ores, so that its production as pure metal required cuet a”
The combined use of SEM-EDX, Raman, ATR-FTIR and visible reflectance techniques for the characterisation of Roman wall painting pigments from Monte d’Oro area (Rome): an insight into red, yellow and pink shades DOI: 10.1007/s11356-021-15085-w -
Acetate confiance 1,0
“cm-1 Furthermore, PC1 was also negatively correlated with the regions at 2929 and 2854 (Ccm-1 H of aliphatic methylene), 1223 (C-O stretching and CH deformation in polysaccharides and lignin, N-H rocking and C-O stretching in amino acids, A”
Huang 等 - 2021 - Prediction of biochemical methane potential of urb DOI: 10.1016/j.scitotenv.2021.147959 -
Hydroxyl (O-H) confiance 1,0
“The peaks between ( cm-1 e 1222.87 and 1145.72 confirmed -OH functional 0.25 c n group of adsorbed moisture and peaks between 1078.21”
Synthesis, characterization and application of novel 1, 3-bis[(furan-2-l)methylene]thiourea functional dye on wool and cotton fabrics DOI: 10.1007/s42452-020-03653-7 -
Acetate confiance 1,0
“Additionally, a strong and intense band given by the cm-1 phenolic C-O stretching between 1223 and 1208 was detected [5,24-28,30].”
What about Phenol Formaldehyde (PF) Foam in Modern-Contemporary Art? Insights into the Unaged and Naturally Aged Material by a Multi-Analytical Approach DOI: 10.3390/polym13121964
Avez-vous un spectre avec cette bande ?
Téléchargez votre spectre FTIR et obtenez un rapport d＇interprétation complet — attributions de pics avec citations bibliographiques, correspondances de bibliothèque et une chaîne de preuves avec évaluation de la confiance — en quelques secondes.