上記のレポートをご覧ください。フォローアップの議論が必要な場合は、以下のコメントをご利用ください。
FTIRパターンはスチレン系芳香族炭化水素ポリマーと最も一致し、ポリスチレンが最も近いライブラリ一致です。この方向性は、3031-3081 cm-1付近の芳香族C-H伸縮、1604および1493 cm-1の芳香族環バンド、701、751、758 cm-1の強い面外芳香族C-Hバンド、ならびに2926および2857 cm-1の脂肪族C-H伸縮によって支持されており、これらは一緒になってフェニル置換炭化水素ポリマーの特徴です。しかし、ライブラリの信頼性は非常に低く、直接的な参照や関連文献の証拠が特定のエンティティ割り当てを独立して確認していないため、最も防御可能な結論は確固たるエンティティ同定ではなく、スチレン系芳香族炭化水素ポリマーの方向性です
推奨される次のステップ: Compare the sample directly against a verified Polystyrene reference spectrum collected under the same ATR or transmission conditions, focusing on the relative intensities and exact positions of the 1604, 1493, 758, and 701 cm-1 bands. Inspect the full spectrum for the typical styrenic fingerprint-region pattern and for any weak heteroatom-associated bands that could indicate additives, oxidation, or copolymerization. If a firmer identification is needed, use complementary methods such as Raman spectroscopy, DSC or TGA, or pyrolysis-GC/MS to distinguish Polystyrene from other styrenic polymers or blends. If the sample is a manufactured article, analyze a cleaned interior cross-section to reduce interference from surface coatings, weathering, or contamination.
| 順位 | マッチ % | 化合物 | SMILES | スペクトル番号 | 操作 |
|---|---|---|---|---|---|
| ライブラリ候補を読み込み中... | |||||
| # | 波数 (cm⁻¹) | 吸光度 | 割り当て | 引用 | 割り当てステータス | |
|---|---|---|---|---|---|---|
| 1 | · | 701 | 1.00 | - | - | - |
| 2 | · | 2926 | 0.92 | - | - | - |
| 3 | · | 1450 | 0.91 | - | - | - |
| 4 | · | 3031 | 0.91 | - | - | - |
| 5 | · | 751 | 0.83 | - | - | - |
| 6 | · | 758 | 0.71 | - | - | - |
| 7 | · | 1493 | 0.41 | - | - | - |
| 8 | · | 3071 | 0.37 | - | - | - |
| 9 | · | 3081 | 0.33 | - | - | - |
| 10 | · | 2857 | 0.31 | - | - | - |
| 11 | · | 1604 | 0.28 | - | - | - |
| 12 | · | 1025 | 0.20 | - | - | - |
| 13 | · | 903 | 0.14 | - | - | - |
| 14 | · | 1070 | 0.13 | - | - | - |
| 15 | · | 1360 | 0.11 | - | - | - |
| 16 | · | 1376 | 0.11 | - | - | - |
このエリアを使用して、解釈を続けたり、質問したり、追加の検証証拠を追加したりしてください。
FTIR.fun
The user from Taiwan (IP: 2407::) uploaded a DOCX file containing three IR spectra. Swipe up to view the qualitative analysis of the first spectrum. The user also expressed intent to calculate sample thickness using interference peaks. Based on the spectra, the analysis was performed at wave numbers 2501 and 2563, yielding an interference peak difference (V₁ - V₂) of 62 cm-1 and ΔN = 1. By inputting the film's refractive index(n), the sample thickness (d) was determined.Here is the original spectrum of the sample extracted from the DOCX file.
en&2