What absorbs at 886 cm⁻¹ in an FTIR spectrum?
A band near 886 cm⁻¹ can point to several functional groups. Below are the most likely assignments, ranked by how much published evidence supports each — every one traceable to literature (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 5 cited sources
Snel antwoord
A band near 886 cm⁻¹ is usually interpreted by checking which functional groups repeatedly co-occur there in the literature, then confirming at least one or two additional peaks in the same sample. This page ranks those assignments by accumulated evidence rather than by a single fixed textbook rule.
Mogelijke functionele-groeptoewijzingen
| Functionele groep | Ondersteunende feiten | Geciteerde bronnen | Hoogste vertrouwen |
|---|---|---|---|
| C-O single bond | 1 | 1 | 1,0 |
| Alkyl C-H | 1 | 1 | 1,0 |
| C c single bond | 1 | 1 | 1,0 |
| Phosphate (PO4) | 1 | 1 | 1,0 |
| Aromatic ring | 1 | 1 | 1,0 |
| Silicon hydride | 1 | 1 | 1,0 |
Ranglijst weerspiegelt cumulatief literatuurbewijs, niet één gezaghebbende regel. Bevestig altijd aan de hand van uw monsterecontext.
Mogelijke materialen
| Materiaal | Ondersteunende pieken | Overlappende groepen | Geciteerde bronnen |
|---|---|---|---|
| sodium alginate | 886, 1636, 1080 | Alkyl C-H, C-O single bond | 1 |
| PLA | 886, 1650, 1073 | Alkyl C-H, C-O single bond | 1 |
Materialen worden alleen getoond wanneer dezelfde literatuurpool deze band en ten minste één extra karakteristieke piek ondersteunt.
Spectrumlogica
This band becomes meaningful only when read with its neighboring peaks. In practice, analysts first look at the assignments above, then check whether the same sample also shows other peaks expected for the same structural motif. A lone band near 886 cm⁻¹ is usually not enough for material identification by itself.
Gebruik in de praktijk
Dit type query komt vaak voor bij polymeeridentificatie, screening van onbekende kunststoffen, probleemoplossing bij QC, verificatie van gerecycled materiaal en literatuurondersteunde beoordeling van piektoewijzing.
Veelgemaakte fouten
- Het behandelen van een enkele geïsoleerde band als bewijs van een materiaal zonder ten minste een of twee ondersteunende pieken te controleren.
- Overlap negeren: meerdere functionele groepen kunnen bijdragen rond hetzelfde golfgetal.
- Validatie overslaan wanneer additieven, mengsels, oxidatie of verontreiniging het spectrum kunnen verstoren.
Advies voor verificatie
Wanneer dubbelzinnigheid blijft bestaan, valideer de hypothese met DSC, GC-MS of TGA, vooral voor mengsels, gedegradeerde monsters en gevulde polymeren.
Literatuur achter deze toewijzingen
-
Silicon hydride vertrouwen 1,0
“cm(cid:50)1 solution, three peaks appear at 807 immersing in Gravimetric porosity of as-etched porous silicon films was cm(cid:50)1 (cid:126)Si-O-Si mode(cid:33), (cid:126)Si-H asymmetric stretching 886 about 70%.”
Huang 和 Zhai - 1997 - Fourier transform infrared study of porous silicon DOI: 10.1116/1.589575 -
Aromatic ring vertrouwen 1,0
“The benzene ring's =C-H bending vibration absorption peaks and benzene ring framework 886cm-1, 823cm-1 801cm-1.”
Li 等 - 2011 - The detection of Cypermethrin on the surface of Ap DOI: 10.4028/www.scientific.net/AMR.287-290.2991 -
Phosphate (PO4) vertrouwen 1,0
“cm(cid:3)1 of montmorillonite is very low, this technique does not 850 to 1350 The bands around 886 are allow the identification of the main characteristic reflecassigned to the asymmetric vibration of the P O bond of 6.63(cid:1)21 cm(cid:3”
Martins 等 - 2022 - The influence of montmorillonite on the flame-reta DOI: 10.3390/POLYM12081701 -
C c single bond vertrouwen 1,0
“cm-1 1461.73 confirms the V symmetry of the CH in 80 2 Lycopene cm-1 lycopene molecule, the vibrational peak at 885.61 60 indicate stretching of C-C-H and C-OH groups of lyco40”
Optimization of pectinase-assisted and tri-solvent-mediated extraction and recovery of lycopene from waste tomato peels DOI: 10.1007/s13205-017-0825-3 -
C-O single bond vertrouwen 1,0
“Additionally, the characteristic ring stretching band of a β-1,4-glycosidic bond was observed at around 886 cm-1.”
Structural and Physical Properties of Alginate Pretreated by High-Pressure Homogenization DOI: 10.3390/polym15153225
Heeft u een spectrum met deze band?
Upload uw FTIR-spectrum en ontvang binnen enkele seconden een volledig interpretatierapport — piektoewijzingen met literatuurverwijzingen, bibliotheekovereenkomsten en een met vertrouwen beoordeelde bewijsketen.