What absorbs at 466 cm⁻¹ in an FTIR spectrum?
A band near 466 cm⁻¹ can point to several functional groups. Below are the most likely assignments, ranked by how much published evidence supports each — every one traceable to literature (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 8 cited sources
Réponse rapide
A band near 466 cm⁻¹ is usually interpreted by checking which functional groups repeatedly co-occur there in the literature, then confirming at least one or two additional peaks in the same sample. This page ranks those assignments by accumulated evidence rather than by a single fixed textbook rule.
Attributions possibles de groupes fonctionnels
| Groupe fonctionnel | Faits à l＇appui | Sources citées | Confiance maximale |
|---|---|---|---|
| Silicon-oxygen (Si-O) | 9 | 8 | 1,0 |
| Silicon (Si) | 4 | 4 | 1,0 |
| Siloxane (Si-O-Si) | 4 | 4 | 1,0 |
| Ring structure | 1 | 1 | 1,0 |
| Secondary amine | 1 | 1 | 1,0 |
| C n single bond | 1 | 1 | 1,0 |
| Amide | 1 | 1 | 1,0 |
| Alkyl C-H | 1 | 1 | 1,0 |
| Hydroxyl (O-H) | 1 | 1 | 1,0 |
| Metal oxygen | 1 | 1 | 0,9 |
Le classement reflète les preuves bibliographiques accumulées, et non une règle faisant autorité. Confirmez toujours dans le contexte de votre échantillon.
Matériaux possibles
| Matériel | Pics de support | Groupes chevauchants | Sources citées |
|---|---|---|---|
| SiO2 | 466, 1739, 699 | Silicon-oxygen (Si-O), Silicon (Si), Siloxane (Si-O-Si) | 2 |
| Silica | 466, 1100, 1080 | Silicon-oxygen (Si-O), Silicon (Si), Siloxane (Si-O-Si) | 1 |
Les matériaux sont affichés uniquement lorsque le même ensemble de littérature soutient cette bande et au moins un pic caractéristique supplémentaire.
Logique du spectre
This band becomes meaningful only when read with its neighboring peaks. In practice, analysts first look at the assignments above, then check whether the same sample also shows other peaks expected for the same structural motif. A lone band near 466 cm⁻¹ is usually not enough for material identification by itself.
Utilisation réelle
Ce type de requête est courant dans l＇identification des polymères, le criblage des plastiques inconnus, le dépannage du contrôle qualité, la vérification des matériaux recyclés et l＇examen de l＇attribution des pics appuyée par la littérature.
Erreurs courantes
- Traiter une bande isolée comme preuve d＇un matériau sans vérifier au moins un ou deux pics de support.
- Ignorer le chevauchement : plusieurs groupes fonctionnels peuvent contribuer près du même nombre d＇onde.
- Sauter la validation lorsque des additifs, des mélanges, l＇oxydation ou la contamination peuvent déformer le spectre.
Conseil de vérification
Lorsque l＇ambiguïté persiste, validez l＇hypothèse avec DSC, GC-MS ou TGA, en particulier pour les mélanges, les échantillons dégradés et les polymères chargés.
Bibliographie derrière ces attributions
-
confiance 1,0
“The [18] located the spectra region at 466 cm-1 and attributed it to the Ti-C vibration.”
Effect of Microstructural and Tribological Behaviors of Sputtered Titanium Carbide Thin Film on Copper Substrate DOI: 10.3390/ma16010174 -
Hydroxyl (O-H) confiance 1,0
“465 PC1, PCB1), (P, PC2, PCB2), (P, PC3, PCB3) and (P, OPS, MRP, RF) predominantly showed 466 characteristic peaks of vibrationally active chemical groups those likely corresponding to hydroxyl USC (cm-1).”
Evaluation of structural integrity and functionality of commercial pectin based edible films incorporated with corn flour, beetroot, orange peel, muesli and rice flour DOI: 10.1016/j.foodhyd.2019.01.022 -
Silicon (Si) confiance 1,0
“The absorption bands of RHA at cm-1 cm-1 466 is ascribed to Si-O distortion, 800 corresponds to Si-O bending, and Si-O-Si stretching appeared cm23.”
Rice husk derived Aminated Silica for the efficient adsorption of different gases DOI: 10.1038/s41598-020-76460-0 -
confiance 1,0
“The absorption peak at 795 was documented in the Si-O-Si group, cm-1 and the detected peak was 466 in the Si-O-Si group [51,52].”
Sustainable Remedy Waste to Generate SiO2 Functionalized on Graphene Oxide for Removal of U(VI) Ions DOI: 10.3390/su14052699 -
Silicon-oxygen (Si-O) confiance 1,0
“The absorption bands at 1097, 1037, 802 and 774 on cm-1 the IR spectra of RHA and WG are assigned to the O-Si-O in the SiO tetrahedron and the band at 466 is”
Lancellotti 等 - 2015 - Geopolymers An option for the valorization of inc DOI: 10.1016/j.ceramint.2014.10.008 -
Silicon-oxygen (Si-O) confiance 1,0
“The bands at around 466 cm-1 for FA-1 and FA-2 are connected with the bending vibrations of O-Si-O present in the silicate tetrahedron [31].”
Structural Characterizations of Aluminosilicates in Two Types of Fly Ash Samples from Shanxi Province, North China DOI: 10.3390/min9060358 -
confiance 1,0
“The Al-O-Si bending band appeared at 520 cm-1 and Si-O-Si bending at 466 cm-1 [63].”
The Antimicrobial Properties of Modified Pharmaceutical Bentonite with Zinc and Copper DOI: 10.3390/pharmaceutics13081190 -
confiance 1,0
“For the test sample, unlike the samples from the calibration set, the Si-O (SiO 2) strain cm-1 vibration absorption band at 466 was noted, which also corresponds to a relatively”
Identification of the Elemental Composition of Granulated Blast Furnace Slag by FTIR-Spectroscopy and Chemometrics DOI: 10.3390/pr10112166
Avez-vous un spectre avec cette bande ?
Téléchargez votre spectre FTIR et obtenez un rapport d＇interprétation complet — attributions de pics avec citations bibliographiques, correspondances de bibliothèque et une chaîne de preuves avec évaluation de la confiance — en quelques secondes.