What absorbs at 583 cm⁻¹ in an FTIR spectrum?
A band near 583 cm⁻¹ can point to several functional groups. Below are the most likely assignments, ranked by how much published evidence supports each — every one traceable to literature (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 8 cited sources
Quick answer
A band near 583 cm⁻¹ is usually interpreted by checking which functional groups repeatedly co-occur there in the literature, then confirming at least one or two additional peaks in the same sample. This page ranks those assignments by accumulated evidence rather than by a single fixed textbook rule.
Attributions possibles de groupes fonctionnels
| Groupe fonctionnel | Faits à l＇appui | Sources citées | Confiance maximale |
|---|---|---|---|
| Metal oxygen | 4 | 4 | 1,0 |
| Alkyl C-H | 2 | 2 | 1,0 |
| Silicon-oxygen (Si-O) | 1 | 1 | 1,0 |
Le classement reflète les preuves bibliographiques accumulées, et non une règle faisant autorité. Confirmez toujours dans le contexte de votre échantillon.
Spectrum logic
This band becomes meaningful only when read with its neighboring peaks. In practice, analysts first look at the assignments above, then check whether the same sample also shows other peaks expected for the same structural motif. A lone band near 583 cm⁻¹ is usually not enough for material identification by itself.
Real-world usage
This type of query is common in polymer identification, unknown plastic screening, QC troubleshooting, recycled-material verification, and literature-backed peak assignment review.
Common mistakes
- Treating one isolated band as proof of a material without checking at least one or two supporting peaks.
- Ignoring overlap: multiple functional groups can contribute near the same wavenumber.
- Skipping validation when additives, blends, oxidation, or contamination may distort the spectrum.
Verification advice
When ambiguity remains, validate the hypothesis with DSC, GC-MS, or TGA, especially for blends, degraded samples, and filled polymers.
Bibliographie derrière ces attributions
-
confiance 1,0
“Triethylgallium was used as the Ga source, and trimethylThe localized vibrational mode (LVM) at 583 cm - ' aluminum or dimethylaluminum hydride were used as the due to C atoms substituting for As atoms in GaAs shows Al source.”
ONO 和 FURUHATA - 1991 - VIBRATIONAL-MODES OF CARBON-ALUMINUM COMPLEXES IN DOI: 10.1063/1.106176 -
confiance 1,0
“FTIR spectra at peaks 583.02 which corresponding to the Fe-O stretching, indicates the characteristic peaks laying in the region be-”
Antibacterial and antiproliferation activity of green synthesized nanoparticles from rhizome extract of Alpinia galangal (L.) Wild DOI: 10.1016/j.inoche.2021.108854 -
confiance 1,0
“O-H at The stretching vibrations of the carboxylic and carbonyl The peak observed at approximately 1727cm-1,and 583cm-1 groupsranged from1720 to the formationof is characteristic of Fe vibrations.”
Alkurdi 等 - 2022 - Development and Evaluation of a Novel Polymer Drug DOI: 10.1155/2022/7903310 -
Metal oxygen confiance 1,0
“Identification of Microorganism Bi in wavelengths of 583 cm-1, 737 cm-1 stretching Sixty-five isolated bacteria from hospitalized patients vibrational of O-Bi-O, and 1630 cm-1 stretching of Bi-O with burn infections was identified following”
Dalvand 等 - 2018 - Inhibitory Effect of Bismuth Oxide Nanoparticles P DOI: 10.21859/ijb.2102 -
confiance 1,0
“The characteristic absorption bands of the sample at 692 and 583 cm-1 were assigned to iron(II) oxide bending, and the band at 459 to 446 cm-1 was”
Hanh 等 - 2023 - Adsorption of Tetracycline by Magnetic Mesoporous DOI: 10.3390/su15064727 -
Alkyl C-H confiance 1,0
“In the case of As (Figure S1e), the stretching vibration ascribed to the asymmetric and symmetric CH stretching 2 cm-1 peak at around 583 of metal oxide at the tetrahedral sites vibrations, respectively, of rGO.”
Iqbal 等 - 2023 - Reduced Graphene Oxide-Modified Spinel Cobalt Ferr DOI: 10.1021/acsomega.2c06636 -
Metal oxygen confiance 1,0
“cm-1 Fe-O Stretching in tetrahedral sites 583 The FT-IR spectra of BT, PT, BTMA, and PTMA are displayed in Figure 5a-d, respectively.”
Influence of Waste Toner on Asphalt Binder: Chemical and Rheological Characterization DOI: 10.3390/molecules28062794 -
confiance 1,0
“dried at vacuum conditions at OH groups attached to the iron absorptions at 583 and cm-1, 3391 respectively.”
Li 等 - 2020 - Solvent-free synthesis of 1-amidoalkyl-2-naphthol DOI: 10.2478/pjct-2020-0012
Avez-vous un spectre avec cette bande ?
Téléchargez votre spectre FTIR et obtenez un rapport d＇interprétation complet — attributions de pics avec citations bibliographiques, correspondances de bibliothèque et une chaîne de preuves avec évaluation de la confiance — en quelques secondes.