What absorbs at 433 cm⁻¹ in an FTIR spectrum?
A band near 433 cm⁻¹ can point to several functional groups. Below are the most likely assignments, ranked by how much published evidence supports each — every one traceable to literature (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 8 cited sources
Kiire vastus
A band near 433 cm⁻¹ is usually interpreted by checking which functional groups repeatedly co-occur there in the literature, then confirming at least one or two additional peaks in the same sample. This page ranks those assignments by accumulated evidence rather than by a single fixed textbook rule.
Võimalikud funktsionaalrühmade määramised
| Funktsionaalrühm | Toetavad faktid | Tsiteeritud allikad | Kõrgeim usaldusväärsus |
|---|---|---|---|
| Metal oxygen | 3 | 3 | 1,0 |
| Phosphate (PO4) | 2 | 2 | 1,0 |
| Water (H2O) | 1 | 1 | 1,0 |
| Hydroxyl (O-H) | 1 | 1 | 1,0 |
Reiting kajastab kogunenud kirjanduslikke tõendeid, mitte ühte autoriteetset reeglit. Kinnitage alati oma proovi kontekstis.
Võimalikud materjalid
| Materjal | Toetavad piigid | Kattuvad rühmad | Tsiteeritud allikad |
|---|---|---|---|
| SiO2 | 433, 1739, 699 | Hydroxyl (O-H), Metal oxygen | 1 |
| hydroxyapatite | 433, 1620, 1639 | Phosphate (PO4), Hydroxyl (O-H) | 1 |
Materjale kuvatakse ainult siis, kui sama kirjanduse kogum toetab seda riba ja vähemalt ühte täiendavat iseloomulikku piiki.
Spektri loogika
This band becomes meaningful only when read with its neighboring peaks. In practice, analysts first look at the assignments above, then check whether the same sample also shows other peaks expected for the same structural motif. A lone band near 433 cm⁻¹ is usually not enough for material identification by itself.
Reaalse maailma kasutus
Seda tüüpi päring on tavaline polümeeri tuvastamisel, tundmatu plasti sõeluuringul, kvaliteedikontrolli probleemide lahendamisel, ringlussevõetud materjali kontrollimisel ja kirjandusel põhineval piirkinnituste ülevaatel.
Levinud vead
- Ühe isoleeritud riba käsitlemine materjali tõendina ilma vähemalt ühte või kahte toetavat piiki kontrollimata.
- Ülekattumise ignoreerimine: mitu funktsionaalrühma võivad anda panuse sama lainearvu lähedal.
- Valideerimise vahelejätmine, kui lisandid, segud, oksüdatsioon või saastumine võivad spektrit moonutada.
Kontrollimise nõuanne
Kui ebakindlus püsib, kinnitage hüpotees DSC, GC-MS või TGA abil, eriti segude, lagunenud proovide ja täidetud polümeeride puhul.
Nende määramiste taga olev kirjandus
-
Phosphate (PO4) usaldusväärsus 1,0
“592cm(cid:1)1 showed the same peaks at 433 and due to internal O492 1.7m2/g) perature was greater at 0% (from 5.7 to and 5% SAID 430 963cm(cid:1)1 43(cid:1) PAO P-O vibration, at due to of the PO and at 1040 493 1.6m2/g) 1.4m2/g) (from 4.7”
Structure reinforcement of porous hydroxyapatite pellets using sodium carbonate as sintering aid: Microstructure, secondary phases and mechanical properties DOI: 10.1016/j.apt.2019.05.013 -
Metal oxygen usaldusväärsus 1,0
“4]2(cid:2) 711-933cm(cid:2)1, tetrahedrons was detected at and The strong W-O stretching in [WO 433cm(cid:2)1.”
Phuruangrat 等 - 2010 - Synthesis, characterisation and photoluminescence DOI: 10.1080/17458080903513276 -
usaldusväärsus 1,0
“From Fourier Transform Infrared cm-1 Spectroscopy (FTIR), the band at 433 is attributed to Zn-O bond Key words: Nanoparticles, Optical properties, XRD”
Pandiyarajan 和 Karthikeyan - 2011 - Optical, phonon and structural analysis of Na dope DOI: 10.1117/12.890082 -
Metal oxygen usaldusväärsus 1,0
“From the FTIR spectrum, a strong peak of 862 has been obtained due to the 42cm-1 stretching vibration of WO in scheelite structure, and a weak but sharp band at 433 has been noticed due to the metal-oxygen (Ca-O) band.”
Abozaid 等 - 2018 - Characterization of Neodymium Doped Calcium Tungst DOI: 10.2298/SOS1804445A -
Phosphate (PO4) usaldusväärsus 1,0
“The peaks at 433 cm-1 and 447 cm-1 were assigned to PO43υ2 vibration (bending mode), and the peaks at 1030 cm-1, 1047 cm-1 and 1079 cm-1 (arb.”
Gavinho 等 - 2023 - An Eco-Friendly Process to Extract Hydroxyapatite DOI: 10.3390/jfb14050279 -
Hydroxyl (O-H) usaldusväärsus 1,0
“The first 3,630 The stretching and bending vibrations of the one (up to 433 K) is attributed to the dehydration of the hydroxyl groups of water molecules present in the clay can cm-1,”
Natkanski 等 - 2013 - Effect of Fe3+ ions present in the structure of po DOI: 10.1007/s10973-013-3225-x -
usaldusväärsus 0,9
“Text: '433 are attributed to ... N bending vibrations'”
Francis 等 - 2016 - Optical nonlinearity in multiferroic bismuth ferri DOI: 10.1016/j.jallcom.2016.07.094 -
usaldusväärsus 0,7
“Lewis Al2Cl peaks assigned”
Understanding the molecular structure of the elastic and thermoreversible AlCl3:urea/polyethylene oxide gel electrolyte DOI: 10.1002/cssc.202001557
Kas teil on selle ribaga spekter?
Laadige üles oma FTIR spekter ja saage sekunditega täielik tõlgendusaruanne — piikide määramised kirjandusviidetega, raamatukogu vasted ja usaldusväärsusega hinnatud tõendite ahel.