Metal sulfur — FTIR absorption peaks and assignments
These are the characteristic FTIR wavenumbers where Metal sulfur tends to absorb, compiled from published literature and ranked by supporting evidence. Each assignment is traceable to a source (DOI) and cross-validated against our 130,000+ reference spectra and knowledge graph.
Backed by 8 cited sources
빠른 답변
Metal sulfur is usually assigned by looking for a recurring cluster of characteristic peaks rather than one exact textbook number. The table below shows where the literature most often places this group in FTIR, ranked by accumulated evidence.
Characteristic FTIR peaks for Metal sulfur
가능한 재료
스펙트럼 로직
여러 예상 밴드가 함께 나타날 때 작용기 할당이 더 신뢰할 수 있습니다. 이 페이지를 사용하여 가장 강력하게 지지되는 피크를 찾은 다음, 동일한 샘플이 단일 고립된 히트가 아닌 일관된 패턴을 보이는지 확인하세요.
실제 사용
이 페이지는 미지 물질 분석, 보고서의 피크 설명, 폴리머 문제 해결, 후보 물질군이 화학적으로 타당한지 확인하는 데 유용합니다.
일반적인 실수
- 스펙트럼의 나머지 부분을 확인하지 않고 하나의 기능 그룹 페이지를 완전한 재료 판정으로 사용하는 것.
- 가장 강한 밴드가 항상 가장 진단적이라고 가정합니다.
- 가공, 첨가제, 노화 및 혼합물이 예상 피크를 이동시키거나 넓힐 수 있다는 것을 잊는 것.
검증 조언
여러 물질군이 유사한 밴드를 공유하거나 혼합 효과로 FTIR 할당이 불확실할 때 DSC, GC-MS 또는 TGA를 사용하십시오.
이 할당의 배경이 되는 문헌
-
600 cm⁻¹ 신뢰도 1.0
“LLM confirmed rule peak-group candidate”
Aziz 等 - 2023 - Water remediation capability of cubic-phase CdS na DOI: 10.15251/DJNB.2023.181.203 -
1000 cm⁻¹ 신뢰도 1.0
“The Fourier Transform Infra Red (FTIR) peak at (cid:2)482 (cid:2)2.56 PACS: appeared due to the simultaneous presence of absorption peaks for CdTe stretching mode as well as Cd-S 78.66.Sq cm(cid:3)1 cm(cid:3)1 Appearance of the broad peak b”
Utilization of residual CdCl2 in CBD-CdS to realize grain growth in CdTe: A novel route DOI: 10.1016/j.materresbull.2013.08.006 -
405 cm⁻¹ 신뢰도 1.0
“LLM confirmed rule peak-group candidate”
60MeV Ni ion induced modifications in nano-CdS/polystyrene composite films DOI: 10.1016/j.radphyschem.2013.06.022 -
670 cm⁻¹ 신뢰도 1.0
“LLM confirmed rule peak-group candidate”
Probing How Various Metal Ions Interact with the Surface of QDs: Implication of the Interaction Event on the Photophysics of QDs DOI: 10.1021/acs.langmuir.1c00548 -
1647 cm⁻¹ 신뢰도 1.0
“A relatively strong and broad FTIR peaks at 1647 and 670 were observed due to the Cd-S bending and stretching vibration in the surfactant mediated films.”
Effect of Triton X-100 surfactant on thiol-amine cosolvents assisted facile synthesized CdS thin films on glass substrate by spin coating method DOI: 10.1007/s42452-020-2423-y -
453 cm⁻¹ 신뢰도 1.0
“An additional cm(cid:1)1 Mo-S appears at 1116.4 and the characteristics peaks of cm(cid:1)1, peak is observed at 453.35 which corresponds to the cm(cid:1)1 cm(cid:1)1.”
Verma 等 - 2021 - The functionalization of polyacrylamide with MoS2 DOI: 10.1039/d0se01877e -
405 cm⁻¹ 신뢰도 1.0
“And peak of the Cd-S bond at 405 was observed, which further testified the generation of CdS nanoparticles.”
Wang 等 - 2007 - Synthesis and characterization of CdSPVA nanocomp DOI: 10.1016/j.apsusc.2007.04.020 -
1389 cm⁻¹ 신뢰도 1.0
“For MoS 2, the vibration cm-1 cm-1 mode at 1389 is assigned to Mo-S vibration, while the vibration mode at 1550 may be S-O asymmetric”
Hydrothermal synthesis of novel 1-aminoperylene diimide/TiO2/MoS2 composite with enhanced photocatalytic activity DOI: 10.1038/s41598-020-78894-y
See Metal sulfur in your own spectrum
FTIR 스펙트럼을 업로드하면 몇 초 안에 전체 해석 보고서(문헌 인용이 포함된 피크 할당, 라이브러리 매칭, 신뢰도 평가 증거 체인)를 받을 수 있습니다.